[Elecraft] K3 psk31 transmit problems

Don Wilhelm w3fpr at embarqmail.com
Sat May 19 13:44:00 EDT 2012


Frank,

Yes, use the same cable that you use for K3 Utility - note which port is 
being used.
Tell DigiPan to use either DTR or RTS to key the K3 and tell it which 
port to use, then go into the K3 menu for CONFIG PTT -- KEY and set the 
PTT to either DTR or RTS (the same as you told DigiPan to use).

The only downside to using DTR or RTS is that when the computer is 
started, those lines will be tested and will become active for a short 
period - the "cure" is to boot the computer and then turn on the K3.

73,
Don W3FPR

On 5/19/2012 10:59 AM, kf4clo wrote:
> Hi All
>   I want to thank everyone for thier help-I still haven't resolved the
> getting Digipan to key the K3 using the line in-line out,lineout-line in,but
> I'm still working on it. I am running windows7-Mic sel is line in-messed
> with the vox gain and the pc speaker volume. I must be missing something. I
> was wondering if I could use my elecraft cable (the one for K3 utility)? If
> so wud I need any other software(like rig controll)to make it key the K3?
> Thanks for your help.
>
> Frank-kf4clo
>


More information about the Elecraft mailing list