[Elecraft] HRD Question

[Rowland R Johnson]

I also had the problem with DM780 freezing the machine. Actually, the 
problem was traced to the serial/USB interface that I was using. 
Specifically, the Proset chip set was used in that interface, which is 
known to have problems. I switched to a serial/USB interface based on 
the FTDI chip set and haven't had a problem since. The serial/USB 
interface sold by Elecraft (KUSB) is based on the FTDI chip set

On 5/9/2012 1:47 PM, Keith Heimbold wrote:
> I just uploaded the new HRD and it has very few controls for the K3. In comparison, I had before a FT950 and it had probably fifty plus slider bar options. It worked real well with the 950 for basic rig control minus the fact that I never had good stable operating of DM780 which is a application freeze machine.
>
> Keith
> AG6AZ
>
> Sent from my iPhone please excuse typos
>
> On May 9, 2012, at 1:44 PM, "Bill"<bill at w2blc.net>  wrote:
>
>> Does the current "free" version of HRD do anything additional for the K3
>> than previous versions? Perhaps allow more sliders or other controls?
>>
>> Bill W2BLC
>>
>> -- 
>> IN GOD I TRUST (but, NOT a single politician)
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>

-- 
Rowland R Johnson
rowland at lascanadas.org

www.lascanadas.org
House 805-438-3673
Cell 805-305-5252
Fax 805-438-4970