[Elecraft] P3 -- Span slow to update

[Arthur Burke]

Do you still have the same baud rate (38400) between the K3 and the P3?
Art - N4PJ



On Mon, May 7, 2012 at 9:02 PM, Charles Johnson <cbjk4zrj at gmail.com> wrote:

> I see the same behavior. P3 without the SVGA board on 1.16 firmware.
>
> 73, Charlie, K4ZRJ
>
> On May 7, 2012, at 8:43 PM, Nate Bargmann wrote:
>
> > A couple of weeks ago I updated the P3 FW from 1.09 to 1.16 and while
> > I've not noticed any improvements since I don't have the SVGA board, I
> > have noticed that the SPAN adjusts very slowly now.  Before the update
> > it adjusted about as fast as the knob was turned but now I can overrun it
> > quite easily or I need to turn the knob quite slowly.  Has anyone else
> > observed this behavior?  If this is the new "normal" I think I'll go
> > back to 1.09!
> >
> > 73, de Nate, N0NB >>
> >
> > --
> >
> > "The optimist proclaims that we live in the best of all
> > possible worlds.  The pessimist fears this is true."
> >
> > Ham radio, Linux, bikes, and more: http://www.n0nb.us
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>