[Elecraft] Issue with new P3/P3SVGA firmware

[Paul Saffren N6HZ]

Hi Ian, 

As far as I know no one else is experiencing this.  When you upgraded to the
new firmware did load both the SVGA and P3?   You can verify this by using
the P3 Utility, it will show the version information of both the P3 and
SVGA. 

-Paul



Ian Kahn - Ham wrote
> 
> I uploaded the new P3/P3SVGA firmware last night, and now I have what
> appears to be a minor, but annoying issue.  When I first boot everything
> up, I have my P3 set up to display both waterfall and bandscope displays.
> However, the P3SVGA only shows the bandscope display.  I have to turn the
> dual display off then back on again in order to get both displays via the
> P3SVGA.  Also, my frequency markers on the SVGA display are reduced to a
> 1-pixel wide line instead of the broader green and purple markers.
> 
> Is anyone else seeing this?  Right now it is just a minor inconvenience,
> but it would be nice if this gets fixed in the next firmware version.
> 
> Thanks and 73,
> 
> -- Ian
> Ian Kahn, KM4IK
> Roswell, GA  EM74ua
> km4ik.ian@
> K3 #281, P3 #688
> HRD v5.x/6.0 Test Team
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at .qth
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> 


--
View this message in context: http://elecraft.365791.n2.nabble.com/Issue-with-new-P3-P3SVGA-firmware-tp7512204p7535960.html
Sent from the Elecraft mailing list archive at Nabble.com.