[Elecraft] Problem with Elecraft's built in 2 meter receiver

[Jim Rhodes]

IIRC, when I installed mine I had to touch up the offsets a bit to get good
audio. Now it sounds good transmit and receive. Got the counter out and
touched up the HF freq, then did the 2 meter. Keyed up into dummy load and
dialed in the frequency that was on the display by changing the offset.

Jim K0XU Sent from my Xoom tablet
On May 4, 2012 9:51 AM, "Julie Royster" <jsdroyster at bellsouth.net> wrote:

> NG5E wonders if Larry and I are new to using a VFO on the 2-meter band, but
> that is not the case, and tuning does not seem to be the issue.
>
> The Elecraft support staff (both Dale and Howard) have been quite attentive
> and helpful.  They have offered to check out the K3 in its entirety.  We
> are
> not criticizing Elecraft support.
>
> We have heard from a few people with a similar problem.  It may well be a
> function of the local repeaters, not the transverter or the K3.  We are
> attempting to find out the transmit bandwidth of the repeaters in question
> (which could be wider than the 13kHz filter), and we are asking another
> local K3 owner to determine if he also gets distortion or clipping on the
> same repeater.
>
> 73,
> Julie Royster KT4JR
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>