[Elecraft] P3: No workee - almost fixed

[Matt Zilmer]

Try the REF LVL control.

matt W6NIA


On Thu, 03 May 2012 22:50:23 +0000, you wrote:

>Well, more-or-less fixed.
>W4TV was the first to suggest setting all the RS-232 rates to 38400, and
>now the communications problem is fixed. Hooray!!
>Now to download the new firmware (it came with 1.13).
>
>One last problem:
>The IF display is off the bottom of the screen - I can only see the peaks
>of the stronger signals (and not 7O6T).
>I just did the IF output gain mod, and at one point the displayed spectrum
>rose above the baseline, but it's gone back down again. I don't seem to be
>able to find a setting that would change the 'vertical position' of the trace.
>While adjusting the "SCALE", the trace pops up for a second or so, then
>disappears back down again.
>
>Tnx for all your help.
>
>Ralph, VE7XF
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html