[Elecraft] K3 Recommendations for Receiver Audio Equalisation

[Joe Subich, W4TV]

For SSB I set the lowest two bands to -16 and set the two highest
bands for -2 (2.4) and -3 (3.6).  This gets rid of LF trash and
takes the edge off of the hiss.

I'm currently experimenting with the lowest two at -16, the next two
flat, 1600 at +3, 2400 at -3 and 3600 at -6 to provide some boost to
intelligibility (the +3 at 1600) and maintaining the hiss reduction.

For CW I set the lowest two bands to -16, then next three bands flat
and the top three to -6, -10, -12.  Leaving the middle three bands
flat allows the full "width" of almost 1000 Hz for off frequency
callers but still gets rid of low frequency trash and high frequency
hiss


73,

    ... Joe, W4TV


On 5/3/2012 6:13 AM, Ray Spreadbury wrote:
> I wonder if there any recommendations for the initial settings to try for
> both the CW and SSB modes in the K3 ?