[Elecraft] P3SVGA

[N5GE]

SVGA setup here is 1440 x 900 Can't set the HP 2311x to 1920 x 1080 because the
right side of the image goes off the screen.

Comments (mostly aesthetic)
1. On the P3 screen Marker A and B cursors are the same width as the vertical
tuning line.  On the VGA display they are at least 2 or three times the width of
the tuning cursor.  The tuning lines and the cursors should be the same width on
the SVGA screen as they are on the P3 display.

2. The tick marks horizontal line at the bottom of the screen are shorter than
the ones on the horizontal line at the top of the screen by a pixel or two.

3. Setting the font size on the SVGA only changes the font size in the label at
the top left of the display.  Example "MKR A:
                                       3.524.00"
4. I like the fill below spectrum line feature.

5. A few times while moving the A and B markers the screen on the SVGA locked
up.  Turning the P3 off and on resets the problem.

Thanks for all you guys do for us.

Tom

Amateur Radio Operator N5GE
ARRL Lifetime Member
QCWA Lifetime Member   
Amateur Radio Operator N5GE
ARRL Lifetime Member
QCWA Lifetime Member