[Elecraft] P3 SVGA

[Bill K9YEQ]

Sit in my shack with all the PC equipment, supplies and monitors running...
what a noisy mess.  When we had a major power outage and I was on my backup
battery the noise floor was so low I had to adjust the ref level on the P3.
Gives one great cause to pack up and go portable.  Great reason for one of
the Elecraft portables, esp. my FT #12 KX3.  Now to get the time to get out
of here.

73,
Bill
K9YEQ


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jim Brown
Sent: Thursday, March 29, 2012 4:22 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] P3 SVGA

On 3/29/2012 2:11 PM, Adrian wrote:
> Sorry Phil, my bad, however a good one will have ferrite molds built 
> on the cable for suppression etc. of course.

Not really. All that ferrite does is get the mfr under the VHF/UHF limits
EMI test lab. It does NOTHING for RF interference below about 100 MHz  It
takes lots of turns through #31 or #43 to make a dent on the HF bands.

73, Jim Brown K9YC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html