[Elecraft] P3SVGA Question

[Vic K2VCO]

Toby,

I've noticed the same issue. The color of the translucent band is less intense (or 
saturated, or whatever -- it's harder to see).

Also, it is not centered correctly -- there is more color on the left than on the right. I 
reported the centering issue as a bug, but I was thinking maybe the color problem had 
something to do with my monitor settings and was intending to check that.

On 3/26/2012 9:49 AM, Toby Pennington wrote:
>
> Yes,  I mean  200hz .  Actually,  the green cursor changes to a dull color barely
> visible from 150hz to 50 hz.  Changing the Span to 10hz will keep this change from
> taking place and the cursor will stay green from 150hz to 50hz.
>
> 10hz is a very narrow Span,  but it is the only way I could find to keep the cursor
> very visible.  I have tried everything with the menu on the P3 and also on the
> monitors,  ( I tried two different ones ) I have changed resolution,  etc.  Nothing
> seems to change this except changing the Span.  It is not a bothersome issue since I
> would normally only tune the bandwidth down that low after I am in contact with
> someone,  and then the position of the cursor is not an issue.
>
> However,  I would like the cursor to retain its color and visibility.     Toby  W4CAK
>
>
> Toby,
>
> I assume you mean 200 Hz?
>
> At any rate, I can turn mine down to the minimum (50 Hz) and still see the green line.
> It's fairly dim at that width but still visible.
>
> Perhaps you can adjust the color and or contrast on your monitor to bring it out.
>
> Rick K6LE

-- 
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/