[Elecraft] P3 w/SVGA - No actual RF Frequency display

[W5RDW]

Got the P3/SVGA today. It was an assembled unit with the SVGA factory
installed. I am powering it off the K3 +12 volt output. The new power cable
is in the mail. It has not shut down after all afternoon and evening ON.
 
It has never displayed the actual RF frequency up in the center top of the
screen or at the left or right side top. Zero is at the top center and the
+/- Spans are at the ends. I can adjust the span as it describes. The
Markers only display the offset from the center, not the RF frequency.
 
I cannot toggle it to the Fixed Mode also. It stays in the Tracking Mode. I
have the latest firmware installed (P3 1.12, K3 MCU 4.39, FPF 1.14, DSP1
2.73). The cables between the P3 and the K3 are per the manual.  I  even
tried a reload of the K3 and P3 firmware and even reinitialized the P3 (page
28 of the manual).
 
I am using an external 19 inch flat panel Acer monitor. Any ideas what I am
doing wrong?

Roger W5RDW  



-----
Roger W5RDW
--
View this message in context: http://elecraft.365791.n2.nabble.com/P3-w-SVGA-No-actual-RF-Frequency-display-tp7394246p7394246.html
Sent from the Elecraft mailing list archive at Nabble.com.