[Elecraft] Diversity Mode Setup

[Cady, Fred]

Hi Joel,
When you get used to the KRX3 it is a great addition to the K3.

Fred Cady
"The Elecraft K3: Design, Configuration and Operation"
www.ke7x.com
 

> 
> I finally got an antenna connected to the KRX3.  I went through the
> operation for diversity mode and I *think* I have this setup right,
but
> I cannot tell if it's actually receiving or not.  From page 45 of the
> KRX3 Installation/Operation Manual:  I hold SUB for 2 seconds and I
get
> the "LINK" indication.  If I hit it for 2 seconds again, I get UNLINK;
> however, the manual states that the kHz decimal point on VFO A should
> blink.  Well, it doesn't, but the kHz decimal point for VFO *does*
> blink.
> 
Start with the VFO's UNLINKed. You have to hold SUB for about 2 seconds
after getting the LINK display. You'll then hear a beep and see the
DIVRSTY display and VFO decimal point flashing.

Just tap SUB to get out of diversity mode.





> Further down on that page, it states that I cannot turn on the preamp
> or
> attenuator unless I hold BSET first.  I hold BSET and get "b SET" on
> the
> display.  Whether I hit PRE or ATT, I get no indication that anything
> has happened.

To set the PRE and ATT for the Sub receiver, turn it on first (tap SUB)
and then hold BSET. Then tap or hold PRE. You can also set the filter
widths in this mode.
> 
> Even further down the same page (and I really don't understand this
> part), it tells me I can select the antenna I am using on the sub
> receiver.  It tells me to hold BSET and then tap ANT.  That works
fine,
> I can select either ANT1 or ANT2.  I have nothing connected to ANT2.
> Is
> this indicating which antenna the *main* receiver is using and not the
> *sub* receiver?  I get the indication from the manual I am selecting
> the
> *sub* receiver antenna which makes no sense to me because my sub
> receiver is the BNC connector.

Again, turn the SUB on before doing this. Then you should see MAIN or
AUX for the sub antenna displayed.

> 
> The manual also states that *holding* RX ANT will accomplish the same
> thing as hold BSET and tapping ANT.  All I get when I hold RX ANT is
> "SUB OFF."  However, if I just tap RX ANT, I get a RX indicator on the
> display.

Turn the SUB on :-)

> 
> I'm really confused with this diversity mode, so please be gentle with
> me.
> 
> Thanks,
> Joel - W4JBB
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html