[Elecraft] P3 current usage

[Alan Bloom]

You can disable the SVGA display with a menu selection, but it makes
only a very small difference in the current consumption.  On mine, the
total P3 current goes from about 590 mA to about 580 mA.  (That's with a
13.8V supply.  The current is higher with a lower supply voltage.)

A modification kit is planned for the K3 that will increase the current
available from the 12VDC OUT jack.

Alan N1AL


On Fri, 2012-03-16 at 16:30 -0500, Oscar Staudt wrote:
> I occasionally take my K3 portable and operate on 12v battery power (no
> computer or monitor).  I was also planning to sometimes take my P3.  After
> I install my P3SVGA board, will my P3 battery current usage go up at all
> times, or can the P3SVGA be disabled/turned off, so the P3 has only the
> older, more modest current draw when I'm portable?
> 
> thanks,
> Oscar, WB5GCX
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>