[Elecraft] [K2] T/R switching

[Don Wilhelm]

As I recall, 500 mV drop across a saturated 2N3906 is not unusual - I 
think all is well.

73,
Don W3FPR

On 3/15/2012 6:55 PM, picmaster at mail.bg wrote:
> Hi Don,
>
> Thanks for your answer. The output of the 8V voltage regulator is just
> perfect (for a 10% device) - 7.98V. I was wondering why I get 500mV
> voltage drop across Q1&  Q2, but if you say that's OK, then I'm fine.
>
> Slightly offtopic - I had also another failure of 2N7000 - again in Control Board,
> but this time Q5 (sidetone generation). I again made the temporary fix with
> BJT+33k resistor, until I order a batch of 2N7000s. Next time I mount those
> picky MOSFETs, I'll try to put a tiny bare wire across all the pins for temp
> protection...
>
> 73,
> Nikolay (LZ1NRD)
>
> -------------------------------------
> Mail.bg: Безплатен e-mail адрес. Най-добрите характеристики на българския пазар - 20 GB пощенска кутия, 1 GB прикрепен файл, безплатен POP3, мобилна версия, SMS известяване и други.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html