[Elecraft] newbie setup questions on memory editor & repeater setup

[Tom Azlin N4ZPT]

Hi Julie,

I have not seen another list response. Perhaps you got direct responses?

The split mode is not necessary for a repeater. See page 29 of the 
manual. I dial in the repeater on one of the VFOs, switch to FM mode, 
then push the Alt key ( hold down mode key) multiple times until it 
switches to the + or - offset I want. When I key the mike the VFO 
displays the offset transmit freq then goes back to the receive freq 
when I let off the PTT. Separately is an offset setting but as I 
remember it was defaulted correctly.

The squelch on my K3 is the RF/SQL knob. Setup on page 53 or around there.

73, tom n4zpt


On 3/14/2012 4:51 PM, Julie Royster wrote:
> Hi from KT4JR, wife of K4MWE, and new co-owner of a K3 with 144mHz
> transverter built in. I have not been able to understand how
> repeaters are supposed to be set up and I am hoping some kind spirit
> out there can clarify for me.
>
> I have entered the repeater frequency in the VFO A cell of the memory
> editor on the computer. I have selected FM so that offset and PL tone
> choices appear next to the VFO B cell. I can put in the offset and PL
> tone, but do I enter a frequency in the VFO B cell? I can't tell
> whether the program would apply the offset to the VFO A frequency or
> to the VFO B frequency, so I don't know whether to put the same entry
> in A and in B, put the actual transmit frequency in B, leave B
> blank, or what.
>
> Say we have a repeater with VFO A frequency at 145.20 mHz and a
> negative offset of 0.6 mHz. So my transmit frequency needs to be
> 144.60
>
> What should my table row look like?  What goes in the VFO B cell?
>
> Name          VFO A    VFO B    offset    PL tone ABC club     145.20
> _____    -0.6       82.5
>
> A related question (why I can't figure out the above) is where on the
> K3 I could actually see the result.  Is there some way I can display
> the frequency I am transmitting on using the display screen of the
> K3?
>
> Do I need to set the K3 to split before using a repeater, in addition
> to setting the above?
>
> If there is a pre-fab dummy guide for repeater set-up, please point
> me toward it!
>
> Finally, I have not figured out the squelch yet either.  is there a
> set-up guide for squelch?
>
> Clearly this radio is amazingly flexible, and I need to keep on
> studying! THANKS for your help! Julie KT4JR in Raleigh, NC
>
> ______________________________________________________________
> Elecraft mailing list Home:
> http://mailman.qth.net/mailman/listinfo/elecraft Help:
> http://mailman.qth.net/mmfaq.htm Post:
> mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net Please help support this
> email list: http://www.qsl.net/donate.html
>
>