[Elecraft] G5RV antenna experience on K3

[Geoffrey Mackenzie-Kennedy]

They do :-) Another way to feed dipoles cut for different bands using a 
single feeder which I find to be less fussy, is to configure the dipoles as 
"Coupled Resonators", with the feeder connected to only one of the dipoles - 
usually to the dipole cut for the lowest frequency band.  The dipole wires 
(tubing in a beam) are run parallel to each other with their mid-points 
facing one another.  The spacing between the dipoles (in wavelengths) 
depends on the wire guage (or tubing diameter).  The ARRL Antenna Handbook 
20th edition covers this scheme in some detail in Chapter 7.

I have a three band wire version (12 - 10 - 6m) here at this time, with a 
plane reflector behind it. 15m yet to be added.

73,

Geoff
LX2AO



On March 09, 2012 at 22:41 +0100, Mike Morrow wrote:


>> I have used duel band dipoles too but found them harder to get set up
>> properly.
>
> That's because they're fighting each other! [duel vs. dual, :-)]