[Elecraft] K3, CM-500 oddity, a follow up

[Mike]

Dick -

Avoid all the adapter cruft and plug the headset into the rear panel. Nothing hanging 
off the front panel to snag stuff. Set Menu|Mic Sel to rP.h, and turn the bias on.

73, Mike NF4L

On 3/8/2012 3:16 PM, Richard Fjeld wrote:
> For the benefit to others like myself, this is a follow-up to the post below.
>
> I have been re-using an adapter made for another radio&headset-mic with my CM-500 mic.  What I didn't know is that there was a 22k resistor in the adapter that bridged the 8V to the tip and ring which were wired common.
>
> I have to admit to being ignorant of how the bias worked. I had thought the 8V on pin 6 would be controlled by the menu option.  Everything was fine until I wanted to try using a Dynamic mic with the same lashup.
>
> As for the CM-500, I'd like to know if it is the tip, or ring, on the 1/8 inch plug that is the actual mic audio lead. I will have to try one, or the other, to see. If anyone else has done this, please let me know.  It would be nice if mic plugs were standardized. Maybe the new ones are, but I don't know what it is.
>
> Thanks,
> Dick, n0ce
>
>
>
>    I bought a CM-500 less than a year ago.  A few days ago, I was trying things, and I turned off the bias, and the mic still works as if, no change.  I tried testing without tearing things apart, and I think the bias is still on.
>
>
>
>    73,
>
>    Richard Fjeld, n0ce
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>