[Elecraft] a bunch of right angle connectors

[Jim Brown]

Yes, junk cables and junk connectors are everywhere, including almost 
all of the vendors who sell to hams and advertise in QST.  Note also 
that the two links here are for ADAPTERS between 2.5mm and 3.5mm  
connectors.  The connector used in the K3 and on nearly all mics and 
headphones is a 3.5 mm (1/8-in, approximately) jack/plug.  The smaller 
2.5mm connector is typically used for remote controls, and on some 
VHF/UHF talkies for either mic or headphones.

The good connector manufacturers are Switchcraft, Neutrik, and 
Amphenol.  Switchcraft and Neutrik audio connectors can be purchased 
online from very good vendors like Full Compass, which is where I buy 
them. Part numbers are in my RFI tutorial and also in the Ham 
Interfacing pdf, both at http://audiosystemsgroup.com/publish.htm   You 
will have to use a soldering iron.

73, Jim K9YC

On 3/4/2012 10:04 AM, ron wrote:
> On 03/04/2012 12:14 PM, Greg wrote:
>> I did a bunch of looking around and these seemed to be the best I could
>> find with a good price and reasonable shipping.  I am sure if you order
>> in bulk from them they would adjust the price accordingly.
>> http://www.pchcables.com/hogmrian2mas.html
>>
>> http://www.pchcables.com/3foan2stmato.html
>
> Caveat Emptor:
> you need to be careful of quality. I recall a writeup (maybe in QST)
> about using poor choice of wire inside the angle connector having effect
> on signal or lost of signal.
> The gist of it was, you get what you paid ....
>