[Elecraft] K3: verifying IF output

[Don Wilhelm]

Matt,

Did you use the same cable to connect to the 2nd rig as you are using to 
connect to LP-Pan?
It would not be the first time a faulty cable was to blame.

73,
Don W3FPR

On 3/4/2012 2:38 PM, Matt Murphy wrote:
> Thanks to Iain and the others who responded off the reflector.  I plugged
> in the K3's IF output to the second rig's sub RX input and sure enough
> heard the same signals.  When the Sub-RX was set to 8.215 MHz it appeared
> that there was about a -1.3 KHz difference between the VFO position that
> would tune in the signal on the K3 vs via the IF.  I imagine this is normal
> (someone please let me know if it's not).
>