[Elecraft] silent subreceiver on 14 MHz, need help

[István Szabó]

Yes, both of you were right. I use only ANT1 & 2 and I checked them 
before. Have not checked the AUX input and the sub was set to AUX. Slow 
mind on Sunday, thank you for the help.
73'

István Szabó



On 3/4/2012 4:00 PM, Guy Olinger K2AV wrote:
> Main ant vs. aux/other ant ant is saved separately by band and which 
> RX, which might cause one the sub RX to seem off as that state is only 
> displayed after BSET (hold on A/B button).  Also true of ATT/PRE. This 
> is also true of the NB and NR state and selection.  If those are set 
> to a "hard" quieting, the RX might seem off.
>
> 73, Guy
>
> 2012/3/4 István Szabó <ha4zd at t-online.hu <mailto:ha4zd at t-online.hu>>
>
>     Just observed that the subreceiver of my K3 does not work on 14 MHz
>     only. When I tune the sub it looks like that the VFO changes its
>     frekvency as I hear "spurr" while tuning. No signal heard coming from
>     antenna input. This phenomena is on 20m only the rest of the bands are
>     fine. No difference between modes. Where shall I start the diagnosis?
>
>     73'
>     István Szabó
>     HA4ZD
>
>     ______________________________________________________________
>     Elecraft mailing list
>     Home: http://mailman.qth.net/mailman/listinfo/elecraft
>     Help: http://mailman.qth.net/mmfaq.htm
>     Post: mailto:Elecraft at mailman.qth.net
>     <mailto:Elecraft at mailman.qth.net>
>
>     This list hosted by: http://www.qsl.net
>     Please help support this email list: http://www.qsl.net/donate.html
>
>