[Elecraft] silent subreceiver on 14 MHz, need help

[Guy Olinger K2AV]

Main ant vs. aux/other ant ant is saved separately by band and which RX,
which might cause one the sub RX to seem off as that state is only
displayed after BSET (hold on A/B button).   Also true of ATT/PRE.  This is
also true of the NB and NR state and selection.  If those are set to a
"hard" quieting, the RX might seem off.

73, Guy

2012/3/4 István Szabó <ha4zd at t-online.hu>

> Just observed that the subreceiver of my K3 does not work on 14 MHz
> only. When I tune the sub it looks like that the VFO changes its
> frekvency as I hear "spurr" while tuning. No signal heard coming from
> antenna input. This phenomena is on 20m only the rest of the bands are
> fine. No difference between modes. Where shall I start the diagnosis?
>
> 73'
> István Szabó
> HA4ZD
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>