[Elecraft] K2 MH2 P1 jumper wiring w/5.6k resistor

[Don Wilhelm]

Gene,

In that case, if there is a 5.6k resistor soldered between pin 6 and pin 
1 on the back of the mic jack, you are all set to use the Elecraft MH2 
microphone.  If the resistor is missing, I would assume the prior owner 
was using a Kenwood microphone or a Heil microphone with a Kenwood 
adapter.  The most you should have to do is add a 5.6k resistor between 
mic jack pin 6 and pin 1.

73,
Don W3FPR

On 3/3/2012 10:05 PM, Gene N4FZ wrote:
> Also, pin 6 is jumpered, +5v.
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/K2-MH2-P1-jumper-wiring-w-5-6k-resistor-tp7341485p7341489.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>