[Elecraft] K3 just goes off - SOLVED

[Rick Bates]

I am not a fan of Powerpole connectors, but use them for compatibility to
other ham gear.  I think they're better than Molex (as an example) but they
are not mechanically secure enough (no locking tab) without adding an
external piece (I tape the crap out of the attached connectors).

 

For high current items (greater than a few amps), I crimp with the proper
tool AND solder (pre-tinning the wire).  One is a mechanical connection, the
other is electrical; either should work; together is insurance.

 

No I don't wear a belt and suspenders (are they still available?); but try
to beat Murphy at his own game every chance I get.  If I EVER get my hands
on him...  :o)

 

73,

Rick wa6nhc

 

-----Original Message-----
From: W0MU Mike Fatchett



Many problems similar to this are caused by a bad crimp job on the 

Anderson connectors.  I would encourage everyone to get the more 

expensive crimp tools with the right dies for the various amperage 

connectors used.

 

Soldering is fine too but not needed if the cable is crimped properly.