[Elecraft] K2 Control Board U3

[Don Wilhelm]

Cameron,

Check the locations of the other 8 pin ICs to be certain their placement 
is correct - in other words, read the numbers printed on the component 
and compare with the location/parts list.
What I am saying is that Elecraft has never had a shortage of ICs, or an 
incorrect count in my 13 years of experience with them (and I have 
assembled a LOT of kits for customers).  But that does not say that 
mistakes cannot happen - but the most likely is that you mounted the 
LM6482 somewhere else.  Check the IC labels carefully with a magnifier 
and a good light.

Once you satisfy yourself that you were shorted an LM6486 and have an 
extra 25LC320, email parts at elecraft.com and request an LM6486. With your 
K2 serial number and order date, there should be no question about 
sending one to you.

73,
Don W3FPR

On 6/23/2012 2:10 PM, Cameron Haines wrote:
> Finishing up this board today and run into a snag. U3 shows to be a LM6482 but I have only the 25lc320 left; is this part a substitute? I looked at part list but did see anything in regards to this part number.
>
> Many thanks,
> Cameron
> AE5UZ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>