[Elecraft] K3 Quickest way to access loose AUX RF nut

[Cady, Fred]

I just swapped the sub rx from one K3 to another. With the right side
panel removed, the aux BNC is right there and you can use a small 7/16
open-end wrench to tighten the nut.
Cheers and 73,

Fred Cady
"The Elecraft K3: Design, Configuration and Operation"
www.ke7x.com

fcady at ieee dot org 
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net [mailto:elecraft-
> bounces at mailman.qth.net] On Behalf Of Erik Basilier
> Sent: Friday, June 22, 2012 11:34 AM
> To: Elecraft at mailman.qth.net
> Subject: [Elecraft] K3 Quickest way to access loose AUX RF nut
> 
> Just pulled my K3 off the operating shelf for travel to Field Day.
> Discovered that the AUX RF BNC connector is quite loose. Started to
> loosen
> adjoining case panels to tighten the nut, but didn't find a way to
> easily
> get at the nut. Since I don't need this connection for FD, and I don't
> have
> time to spend, I will just defer fixing the problem until I get home.
> However, if there is a best way to do the job, without removing the
> second
> RX etc, I'd like to know. Any advice?
> 
> 
> 
> Thanks and 73,
> 
> Erik K7TV
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html