[Elecraft] P 3 COCKPIT ERROR I AM SURE.

[Alan Bloom]

Hi Paul,

I think what you're asking is why the P3's VFO B cursor flashes when you
tune the VFO A cursor rapidly   That is caused by the fact that the VFO
B cursor does not update as rapidly as the VFO A cursor.  There are a
couple solutions:

- Unlink the VFOs on the K3 by holding the SUB button.
- Turn off the VFO B cursor in the P3 via MENU: VFO B

Alan N1AL


On Wed, 2012-06-20 at 14:28 -0400, Paul VanOveren wrote:
> I must have changed something in the configuration of my P3... With the cursor type set as “bar” and in the the “finest” rate,  3 # to the right of the decimal, everything is fine. In the next coarser rate, 2 # to the right of decimal, I get a line, like the B marker is on, on the left edge of the curser. In the coarsest rate, 1 # to the right of the decimal, if I tune the A VFO rather rapidly, I get flashing B marker lines, above and below the center frequency curser..
> Maybe what I am asking is how to shut the Purple VFO  cursor off,  it moves with either the A VFO or the B VFO..
> 
> NF8J
> Paul 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>