[Elecraft] Another KPA500 assembly problem

[Nick]

Emory,
you are not alone, the same issue here.
Dale from Elecraft promised send another on Monday

Nick, VE3FJ


On 6/17/12 5:36 PM, WM3M wrote:
> While putting the KPA500 front panel together, I realized I was sent the wrong plastic bezel.
> Its not even close to the correct size.
> I think I will continue with the KPA500 assembly, and if needed install the plastic bezel when I get the right one.  It should be fine to operate without it as long as I am careful?
> I don’t think there is anything else wrong or missing but I have not powered it up yet.
> Emory  WM3M
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html