[Elecraft] New K3--CW QRQ Problem

[Guy Olinger K2AV]

Hi Mike,   What is CONFIG:TX DLY set to?   73, Guy.

On Fri, Jun 8, 2012 at 12:41 AM, Michael Marx <sndtubes at vacuumtubes.com>wrote:

> Hey all,
>
> I just  built my new K3-100.  All seems to be fine except when I try to
> use CW QRQ mode.  When I select this mode, I only have about 5 watts of
> power output no matter where the power setting is.  Elecraft says that the
> CW QRQ mode has nothing to do with power output, yet I have the problem.  I
> am using the built in wattmeter and an external wattmeter.  When I switch
> CW QRQ off, the power comes back to full.  I did a reset at Elecraft's
> recommendation and it did not resolve the problem.  I also loaded the
> newest firmware (which it should have had anyway) and no solution to the
> problem.  Any ideas out there
>
> 73,
> Mike  WB0SND
>
> Michael Marx
> sndtubes at vacuumtubes.com
>
> www.vacuumtubes.com
> SND Tube Sales
> 105 N. Division St.
> Bonne Terre, MO  63628
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>