[Elecraft] K3 transmit audio cuts out

[David Bunte]

Don -

I have not been following this thread very carefully, but am a bit baffled
by your response to Keith.  He talked about not getting a "solid click"
when plugging the DC cable into the back of the K3... it sounds like you
are talking about the "click" when inserting the terminal into the APP.

I have NEVER had a "click" when plugging a power pole into another power
pole, whether on the rear of my K3, or in-line.  In fact, the power poles
disconnect from the rear of the K3 with such ease that if I move the rig,
even a little, I OFTEN have to plug the DC back into the rear of the K3.

I thought that perhaps I did not understand what you were telling him, so I
looked at the XV download link you referenced, and cannot find the diagram
to which you make reference.

Dave - K9FN

On Sun, Jul 29, 2012 at 12:22 AM, Don Wilhelm <w3fpr at embarqmail.com> wrote:

> Keith,
> .....
>
> If your APP connectors do not fit together and "latch" in place, it is
> likely that you have not assembled them properly.  Take a look at the
> diagram on page 37 of the XV transverter manual Download from
>
> http://www.elecraft.com/manual/XV%20Transverter%20Owner%27s%20Manual%20Rev%20F.pdf
> .
>
> Figure 29  is the best description of the proper locking of the APP
> blades into the housing.
>
>