[Elecraft] Follow up on Weird happening this morning

[Jim Sheldon]

In trying to duplicate this, I turned split off, and then turned it back on using the SPLIT key (hold A>B) and split shows on the K3's LCD, but VFO B Cursor on both the P3 and SVGA stay purple and split does not operate properly on the K3 - TX stays on VFO A.

I did have DATA display turned on on the SVGA.  

Immediately after I turned DATA display off, the cursors changed to red and VFO B went to the proper frequency.  I verified this with a frequency counter.

For Paul Saffren,
There appears to be an improper interaction between the P3/SVGA and the K3's SPLIT mode when the Data display is active.  The band where this happened was 15 meters and the mode was CW.

I'm now going to run a few further checks to see if this is global or just on one band.  Everyone else using the SVGA and the Beta FW for the Data display might want to watch for this as well..

Jim - W0EB

> While trying to work CY9M (I got 'em) I had the K3 set up for
> split, split was showing in the window, had VFO B set to about 3
> KHz UP where they were listening.  The P3's cursor stayed purple
> (including the one on the SVGA display) and I got yelled at for
> transmitting on the DX station's frequency.  First time I've ever
> had the K3 display "SPLIT" on the LCD and not actually be in that
> mode.
>
> Anyone else have this happen?  Either before or since 4.51?
>
> Jim - W0EB
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html