[Elecraft] Microphones - Yaesu MH-31
Don Wilhelm
w3fpr at embarqmail.com
Fri Jul 27 08:08:35 EDT 2012
Steve,
The only thing I can say is that there is more than enough audio drive
with my MH3 microphone.
Does your MH-31 work with plenty of audio on your FT-817 or FT-857?
My numbering scheme was consistent with a left to right convention
looking into the jack opening (like the diagram in the FT-817 manual.
If you were looking at the end of the plug, the numbers would be reversed.
73,
Don W3FPR
On 7/26/2012 10:58 PM, Steve KC8QVO wrote:
> Don Wilhelm-4 wrote
>> Pin 4 goes to the tip
>> Pin 5 goes to the shell
>> Pin 3 goes to Ring 1
>> Pin 2 goes to Ring 2
>>
> Don,
>
> Your numbering was backwards from what I used, but I translated the numbers
> from the other direction (made 8 = 1, 1 = 8, and the others in between to
> match) and got the same pin designations and wire colors. However, I took
> (your numbers) pin 2 and pin 5 and grounded them to the shell together (pin
> 2 shows as mic ground in the schematics so I figured I'd ground it to the
> regular ground also). After looking over your numbers I moved the regular
> ground (your pin 2) to ring 2. This gave me the same results as before.
>
> If I crank the power up I can get some deflection in the power meter, but I
> can't get the ALC meter to budge on max mic gain and max compression.
>
> I just tested the output with a pair of headphones on. I took the
> compression off (0) and as I increased it the audio volume from the monitor
> circuit got louder.
>
> Just out of curiosity - what are some others using for microphones and what
> settings are you finding work for those microphones?
>
> My experience with other rigs is that if the mic gain is too high the audio
> distorts, likewise if the compression is too high it distorts. Here I have
> both gain and compression max'ed out and seemingly not getting enough. That
> doesn't make much sense to me, but I know the KX3 is a different rig. Is
> that perhaps a change that can be made in software? Or am I at the limits of
> the hardware?
>
> Steve, KC8QVO
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/Microphones-Yaesu-MH-31-tp7559727p7559858.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
More information about the Elecraft
mailing list