[Elecraft] Best sequence to install

[Ron D'Eau Claire]

I suspect one order is as good as another, since they go in three different
areas of the K3: DVR in the front panel assembly, filter on the main RF
board, and the KXV3A on the rear panel.

If you have the KRX3 sub-receiver installed, you'll have to remove it to
install the filter and having the main KRX3 module out makes installing the
KXV3A much easier, so I'd recommend pulling that and leaving it out until
you've installed and tested all three options. If you have the K144XV
2-meter module installed, you'll need to remove it to get the KRX3 module
out, so I'd put that back last, after the KRX3 module is back in and tested.


73, Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Mark Kempisty
Sent: Friday, July 20, 2012 10:40 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Best sequence to install

I'm planning to add a few options to my K3 that I didn't get when I ordered
it.  The DVR, KXV3A and broadcast band filter.  Since I wold like to only go
into the radio once I plan to order all three at the same time.

Any suggestions on the best way to tackle installation of these three
divergent options?  About the only common thing among them is taking the
covers off.

 
Take care,
Mark
AA3K
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html