[Elecraft] [KX3] Fix for my KX3 speaker distortion / buzzing

[Wayne Burdick]

Art Nienhouse wrote:
> I found the fix for my speaker buzzing which was the fit of the  
> speaker grill fit between the upper half and the lower half of the  
> case.
> I filed the lower case for clearance on the sides of the speaker the  
> vertical part on the lower case half both sides I now have 1/16 inch  
> on the vertical sides and just a bit less on the lower side.
>
Art,

This is probably a lot more clearance than is necessary. It sounds  
like all that is really required is to avoid direct edgewise contact  
between the top and bottom covers around the perimeter of the speaker.

But I'm glad you found that this helps, and I'm modifying the top and  
bottom cover drawings so that the very next production run of  
enclosures will benefit from the change.

> Before I reassembled the case halves I bent in just a bit the very  
> bottom of the speaker grill across the bottom.
>
I'm not sure why that would be necessary except to achieve the same  
kind of clearance between top and bottom covers (around the entire  
perimeter of the speaker "isthmus"). Again, I'm increasing this  
clearance in the mechanical drawing.

73,
Wayne
N6KR