[Elecraft] KX3 - Calibrating Frequency/Aligning?

[Don Wilhelm]

Steve,

Start with REF CAL at 114.321.44.
Yes, there is just one setting for all bands.  I suggest using WWV at 
the highest frequency you can receive it.
Follow the instructions for calibrating REF CAL in the manual.
If that is done correctly and you have a significant error on the bands, 
you have something else wrong and you should contact support.

73,
Don W3FPR

On 7/15/2012 9:57 AM, Steve KC8QVO wrote:
> Can a few of you give me your cal numbers? I threw mine off. I didn't write
> the number down because it was so far off, got it tuned on 40 meters just
> right, then went to tune it on 30 and it was out of the ball park. Now I'm
> trying to get it tuned on 40 again.
>
> I guess its just one cal number across the board. That has me a bit worried.
> Based on my numbers before as the frequency went up the frequency error went
> up too. I am not sure that will calibrate out, but I'll give it a shot.
>
> Steve, KC8QVO
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/KX3-Calibrating-Frequency-Aligning-tp7559098p7559138.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>