[Elecraft] KX3 - Calibrating Frequency/Aligning?

[Don Wilhelm]

Steve,

The frequency calibration is in the manual.

Refer to the KX3 manual beginning on page 31 to calibrate your reference 
frequency..  That procedure should achieve an accuracy better then +/- 1 
ppm.

73,
Don W3FPR

On 7/14/2012 10:09 PM, Steve KC8QVO wrote:
> Here are some more numbers:
>
>          FT857D / KX3
> 160:     1800 / 1801.18
> 80:     3.500 /3.502.35
> 40:     7.000 / 7.004.76
> 30:   10.100 / 10.106.88
> 20:   14.000 / 14.009.55
> 17:   18.100 / 18.112.37
> 15:   21.000 / 21.014.36
> 12:   24.900 / 24.917.1
> 10:   28.000 / 28.019.18
> 6:    50.100 / 50.134.32
>
> These were all measured on CW. I have a service monitor back home so I have
> a better reference to use, just not with me right now. If there is an
> alignment procedure that would be a big help.
>
> Steve, KC8QVO
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/KX3-Calibrating-Frequency-Aligning-tp7559098p7559113.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>