[Elecraft] P3 TX Audio monitoring

[vk4tux]

Gary, I had replied to your post, perhaps it went to you direct and I am on
your naughty list ? ;)

Anyhow if the K3 baud rate (rs-232 config) is not 38400 then that will do
it.

Some versions of firmware in the past would sync the K3-P3 to 38400, but I
am not sure now.
Anyhow check the baud rate. I used that trick with a PF assigned to change
K3 baud rate to other than 38400 to chk my TX. It was good for one over and
then would re-sync back to 38400. 

cheers

Adrian

--
View this message in context: http://elecraft.365791.n2.nabble.com/P3-TX-Audio-monitoring-tp7558585p7558602.html
Sent from the Elecraft mailing list archive at Nabble.com.