[Elecraft] K2 Alignment and Test, Part II - No signal on TP3

[David Moorman]

Do you have a receiver you can listen on to see if the oscillator is actually oscillating?  

Dave K9SW



On Jul 3, 2012, at 6:41 PM, Cameron Haines <camhaines at yahoo.com> wrote:

> Correction.
> 
> 
> Hey Guys,
> 
> Well, I am at the part where I need to test the 4 MHz oscillator calibration and ran into a snag. I am not getting anything on two different frequency counters when connected to TP3. Test up to this point have been good. Checked all the components around X1 and all look correct. No error message on startup. 
> 
> Any ideas where to go from here?
> 
> Thanks,
> Cameron
> AE5UZ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html