[Elecraft] K3 sub receiver no signals

[Ron D'Eau Claire]

Is the antenna connected? Seriously, Mike, there are several menu options
for where the 2nd rx will get its signals. I'd bet you have an unused input
selected. 

The sub receiver gets its RF input either from the main receiver (sharing
ANT 1-2 or RX ANT IN), or from its auxiliary antenna input. If you have a
cable connected to the KRX3 module's AUX input you have the following
choices in the CONFIG menu under KRX3:

ANT=BNC: Specifies that the KRX3's auxiliary antenna source is the AUX RF
BNC jack on the rear panel. This requires that the BNC is installed with its
cable connected KRX3's AUX RF input.

ANT=ATU: Specifies that the KRX3's auxiliary antenna source is the ATU's
non-transmit antenna (1 or 2).Use this setting only if you connected the
KRX3's AUX RF input to the KAT3's TMP jack.

73, Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of W0MU Mike Fatchett
Sent: Sunday, July 01, 2012 7:32 PM
To: Elecraft Reflector
Subject: [Elecraft] K3 sub receiver no signals

I installed this 2nd receiver quite some time ago.  I probably never checked
but i hear background noise in the sub receiver but no signals.  
I suspect this is something stupid, can someone point me in a direction.

--
Mike W0MU

W0MU-1 CC Cluster w0mu.net

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html