[Elecraft] ERR BP2

[Georgek5kg at aol.com]

What is the cure for an ERR BP2 in a K3?  The manual says to  de-install 
KBPF3 on the RF board.  This sounds serious and  complicated.
 
Is this an error msg that must be fixed, or can it wait until our crew  
returns from a dxpedition?
 
73, George
 
George  Wagner, K5KG
Sarasota, FL 
941-400-1960 cell  

 
  
____________________________________
 From: w1md at cfl.rr.com
To: bob at wa1z.net
CC: Georgek5kg at aol.com,  k1xx at cfl.rr.com, waf945 at aol.com, jrcccd at aol.com, 
jcclark at myfairpoint.net,  mdurham at harris.com, k1qx at arrl.net, 
ccarroll at onyx-ware.com,  w1md at arrl.net
Sent: 1/29/2012 4:31:44 P.M. Eastern Standard Time
Subj:  RE: PJ4


Sunday afternoon update.

Got the 500hz filter  installed and calibrated per the info from the 
factory.
Installed the ext.  RX board as well. All seems good at the moment.

Bob/George, still  getting the ERR BP2 at initial power up  though.

MD


-----Original Message-----
From: Bob Raymond,  WA1Z [mailto:bob at wa1z.net] 
Sent: Sunday, January 29, 2012 7:26 AM
To:  <w1md at cfl.rr.com>
Cc: Georgek5kg at aol.com; k1xx at cfl.rr.com;  waf945 at aol.com; jrcccd at aol.com;
jcclark at myfairpoint.net;  mdurham at harris.com; k1qx at arrl.net;
ccarroll at onyx-ware.com;  w1md at arrl.net
Subject: Re: PJ4

Marty, what is the specific error  code/message on the K3 display?

>