[Elecraft] AGC and SSB - Low signals after Xmit

[ab2tc]

Hi,

Did you use slow AGC and was the RX gain still reduced (from a strong RX
signal) when you started your transmission? If yes to both, it works as
intended. The RX starts back up with the AGC level as it was just before
transmission started.

AB2TC - Knut


Lee Buller wrote
> 
> I this weekend's NAQP SSB contest, I notice times when the K3 went to
> receive 
> the audio volume was low...less signal...but then recovered after a few
> seconds 
> or on the next transmission cycle.
> 
> Is there something going on with the AGC?  My K3 is very standard...run of
> the 
> mill settings....slow AGC...factory settings.  But it seems the receiver
> did not 
> come back fast enough after Xmit.
> 
> Comments?
> 
> Lee - K0WA
> 
> <snip>
> 


--
View this message in context: http://elecraft.365791.n2.nabble.com/AGC-and-SSB-Low-signals-after-Xmit-tp7217053p7217259.html
Sent from the Elecraft mailing list archive at Nabble.com.