[Elecraft] Freq Counter for Receiver align

[Don Wilhelm]

Don,

I suggest you skip that.  First of all, the 100 hZ increments are not 
close enough, and secondly, the exact frequency of the 4 MHz reference 
may end up slightly different than 4 MHz.
Wait until you have fully assembled your K2 and then go to my website 
www.w3fpr.com and do the K2 Dial Calibration procedure - it will put the 
4 MHz reference on the correct frequency and give you correct dial 
calibration.

73,
Don W3FPR

On 1/21/2012 6:40 AM, Don Baucom wrote:
> I have a chance to pickup a Kenwood DG-5 freq. display for my TS-520SE. It is
> also a 40mhz counter in 100hz increments. Could I use it for the 4 mhz
> oscillator Calibration on page 63. Is the DG-5 accruate enough for this
> purpose.
>
> Im getting close to this test point ( Im putting the crystals in today and
> will wind some toriods)
>
>