[Elecraft] PR6 Installation

[Ron D'Eau Claire]

Did you remove jumper P2 as shown in Fig 3 in the manual? That's required
for Digout1 to control the PR6. 

Ron AC7AC

-----Original Message-----

I have my 6M antenna connected at Ant 2, with the PR6 installed at the RX
Ant
BNC's and config on DigOut1  set to "On". Once I hit the RX Ant button, I
hear nothing. Is the 6M antenna supposed to be routed into PR6's BNC
connector instead of Ant 1 or 2?
thanks,
N6SC

--