[Elecraft] SOLVED (almost) Unwanted output K3 in transvertermode

[Eric-Jan Wösten]

Guys,

 

I solved by re-reading the manual (grin) and changing XVn PWR. This sets
maximum K3 power output for

the current transverter band, in two ranges: L .01 - L1.27 specifies a power
level in milliwatts; 

Lowering the L value to 0.50 was the solution. Now I still have full output
on 70 MHz.

Limiting output power of the transverter to 2 watts  by lowering L even
further works but then the output

indicated on the LCD doesn’t change when turning the power knob.

 

 

vy 73 Eric-Jan Wösten, PA3CEV