[Elecraft] K3 per band power levels with KPA500

[Phil Hystad]

I went to read the documentation and set up the per band power levels for the KPA500 in standby (barefoot) and operate (powered) mode and discovered that the directions were not as clear as I prefer for my feeble mind.

So, I read that the CONFIG menu setting of PWRSET is set to PER BAND instead of NORmal but after that I am not sure what I need to do and how something gets "saved".  Did I miss something in the documentation or am I looking too hard?

Also if you are running in the per band and then want to change the power level for that per band setting do you just use the PWR knob to adjust the power level to your liking and if you do that is it automatically saved?

Thanks for any help you will be.

73, phil, K7PEH