[Elecraft] K24U Software

[Heinz Baertschi]

Dan,

I can reproduce the error messages stated by simply configuring K2 PORT=OFF. 
So if your K2 serial Port is set to ON, make sure the K2 to Computer Cable
Assembly is correct (e.g. as in KIO2 Manual, Figure 7).
CAUTION: Do not use a pre-assembled cable of any kind (printer cable, etc.)
between the KIO2 and a computer.

73,
Heinz  HB9BCB


On Jan 05, 2012; 6:58pm Dan Mees wrote:

... When I click Connect... I get a window that sez "K2 communication Link
Has Been Reset."  I click OK.... but get no joy.  ...


--
View this message in context: http://elecraft.365791.n2.nabble.com/K24U-Software-tp7155405p7157794.html
Sent from the Elecraft mailing list archive at Nabble.com.