[Elecraft] K2 KSB2 alignment: Cannot find the point to connect TP2 to?

[Don Wilhelm]

Andreas,

I assume you have the internal Frequency Counter Probe that was 
assembled during Assembly and Test Part II.  That is the probe that 
plugs into TP2 - the other end connects to the Control Board connector 
on the top left corner.

73,
Don W3FPR

On 1/4/2012 8:47 PM, Andreas Hofmann wrote:
> Stupid question, I have found the round female TP2-labeled point, but not the point where the other side goes to. Looked for 10 mins but no success.  Can someone point me to the right label on the RF board?
>
> Thanks
> Andreas
>
>