[Elecraft] K2 4MHz Adjust...

[Don Wilhelm]

I suggest you use the N6KR method to set the 4 MHz reference 
oscillator.  Refer to my website www.w3fpr.com article on K2 Dial 
Calibration.  Note that the actual frequency may not be at 4 MHz.

You may use any AM station that has a known carrier frequency rather 
than WWV.  If you use a standard station that transmits only a carrier, 
you will still have to use SSB mode, but switch to CW to adjust the 
pitch equal to your sidetone pitch.

73,
Don W3FPR

On 1/4/2012 8:38 AM, EB1TR wrote:
> Hello to all, this week (my last hollidays week) I thought it would be a good
> idea to adjust the oscillator 4MHz my K2.
>
> I performed the steps as it is described in several ways but the result is
> always the same.
>
> 40 meters LSB 200Hz shift
> 40 meters USB 1.5KHz shit
>
> In other bands the results are always similar. Any ideas?
>