[Elecraft] Trying to get to grips with the KDSP2 Filter

[Ray G3XLG]

I am the 2nd owner of my K2 and have so far largely "ignored" the DSP filter
but I thought I'd look into it further following my poor performance in a
recent RTTY contest where some contacts were difficult but eventually OK and
others were unable to decode my signals at all.
So far I have found the DSP filter settings currently in the K2 are as
follows:
SSB 
S1. .00  2.9
S2. .20  .2.5
S3. .30  .1.9
S4.  .30 .1.6 
Which I understand show that the denoiser is not currently activated, the
notch is on and the other figures are the lower & upper cutoff frequencies
in kHz.
CW
CF1  nr
CF2  nr
CF3  nr
CF4  nr
So it appears my DSP is not active on CW?
RTTY
r1  LPA.SS
r2 2.5  .1.0
r3 2.2  .30
r4 1.0  .20
I think this shows the centre frequencies of 1 to 2.5kHz & the width of 0.2
to 1.0kHz with filters r2, r3 & r4?

My questions are:
- why would the CW filters not be active & what does "nr" mean?
- what are typical DSP settings for RTTY, and are the ones in use OK?
- any other comments re these settings?

Still learning about this rig!
73
Ray, G3XLG


-----
Ray G3XLG
--
View this message in context: http://elecraft.365791.n2.nabble.com/Trying-to-get-to-grips-with-the-KDSP2-Filter-tp7146478p7146478.html
Sent from the Elecraft mailing list archive at Nabble.com.