[Elecraft] K3, I broke it. Headed for the schematics

[Jim Miller KG0KP]

Fixed it.  reinstalling the second receiver pulled out a cable to a front 
panel board and the end was under the receiver so I couldn't see it.  Once 
it was removed, it was obvious.  Thanks guys.

73, de Jim KG0KP

----- Original Message ----- 
From: "Jim Miller KG0KP" <JimMiller at STL-OnLine.Net>
To: "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: Tuesday, January 03, 2012 7:50 PM
Subject: [Elecraft] K3, I broke it. Headed for the schematics


> OK, Magic people, I broke it.  First responses are the right ones.  I
> installed the 2m internal module (physically) and the FM Filter.  Audio 
> gone
> even before utility ran to configure filters ("all bands").
>
> No audio through speaker or headset (front connections) except white 
> noise,
> no signals.  I see the signals on my P3 just as they should be.  Normal
> amplitude, etc.  The only connections to the 2 meter module is power, 
> other
> cables not connected.
>
> Any ideas where the connector is that I somehow disconnected?
>
> Headed for the schematics.
>
> Filters were #1 was 2.7, #2 was 1.8, #3 was blank, #4 was 500, #5 was 250
> Filters now #1 is 13.0, #2 is 2.7, #3 is 1.8, #4 is 500, #5 is 250
> In config - just moved settings for #2 to #3 and #1 to #2 and added #1 as
> 13.0 and set for FM but NOT installed.
>
> Thanks es 73, de Jim KG0KP
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>