[Elecraft] K3, KPA500, StepIRR, Navigator, PC cabling

[Rick Tavan N6XI]

Don's suggestion will get the SteppIR controller tracking K3 frequency.
I've done it. But I abandoned the idea because every time I crossed a
segment boundary (every 25 or 50 KHz?), the SteppIR would briefly retune,
generating a bit of RFI and suspending my amp until done. I found that
annoying and went back to the band buttons. Now the SteppIR only retunes
when I want it to.

/Rick N6XI

On Fri, Feb 24, 2012 at 2:19 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:

>
> Plug the SteppIR cable into the Y that connects to the K3.  The SteppIR
> has only receivers and just listens on the conversation between the
> computer Navigator) and the K3 - that is OK since no drivers are involved.
>
>
-- 
Rick Tavan N6XI
Truckee, CA